Chrisnik Pipe Mic II

Full Product Info

Features and Specifications:

• Features:
  • Pin setting for measuring a 1 ft vertical offset: By pulling a pin you can go from 0 to 1ft vertical offset for clearance under rod
  • New round foot design slices through material at the bottom of the pipe and insures accurate invert and pipe diameter measurement
  • Measures the depth of pipe invert from top of rim
  • Measurements are more accurate because you are measuring with vertically plumb rod
  • 24" measuring arm can be extended to 36" by adding 1ft extension (sold separately)
  • Made of lightweight (2 lb) non-rusting aircraft aluminum
  • Made for Crain 25' SVR and USL rods
  • No tools needed to attach to rod
  • Slides on and off rod in seconds
• To use:
  • You can direct read the depth of the invert when the pin is set at "zero offset" on the Pipe Mic.
  • If you need clearance under rod to measure an invert move the pin to "1' vertical offset hole"
  • If you need clearance under rod and a pipe that is hard to reach you can add a 1 ft.
• To size a pipe:
  • The foot is 0.33 or 4". Take the reading from the rim, pull up and take reading plus 0.33 and that is your pipe size.
  • Example: 4" Pipe = 0.00 movement, 6" Pipe = 0.17, 8" Pipe = 0.33, 10" Pipe = 0.50, 12" Pipe = 0.67.

You may also like:

Mens Cotton Tactical Pants
As Low As $39.99

Distance Measuring Wheel, 2 Wheels, Feet/Inches
As Low As $51.99

Storm Jacket
As Low As $45.99

Mens Tactical Shorts
As Low As $19.99